Dimplex CX-WIFI-A El Manual Del Propietario página 13

Initial Setup
! NOTE: At any time, holding
down the temperature set point
will toggle the temperature mea-
surement preference.
Heater Synchronization
The controller features CON-
NEX , a wireless technology
TM
that works with Dimplex CON-
NEX enabled heaters to provide
TM
simple whole home connectivity
and comfort. CONNEX
lers are available to control one
or multiple heaters within a 50'
(15 m) radius. In order for the
controller to have this function
the CONNEX
TM
and the controller will need to be
synchronized.
! NOTE: For ease of setup, it is
suggested that the controller be
taken to each heater to complete
the synchronization process. The
controller is equipped with a small
battery that will allow the unit to
be unplugged from the wall, for
up to 3 hours, to be able to move
to each heater for synchroniza-
tion. Synchronization can be
completed after the battery has
died, by moving the controller to
each heater and plugging it into a
nearby receptacle.
CAUTION: Always press the
control-
TM
enabled heater
icons with a blunt object. Sharp
objects like pen and pencil points
may damage the touch screen.
1. Press the
controller into synchronization
mode.
2. All four (4) zone icons will
begin to flash.
3. Select the zone that the spe-
cific heater will be associated
with. That icon will become
solid.
4. On the heater press and hold
the V button for 3 seconds,
both the
begin to flash.
5. Press the – , ✚ and then V,
on the heater.
6. Within 10 seconds press the
icon on the controller.
! NOTE: When the synchroniza-
tion is complete the display on
the heater will switch to the new
settings from the controller.
7. Repeat steps 3-5 until all of
the heaters are synchronized.
8. Press the
back to operation mode.
! NOTE: When the controller is
running on battery power, Wi-Fi
function is disabled.
icon to put the
and icons will
icon to revert
13