Dimplex CX-WIFI-A El Manual Del Propietario página 9

Installation
most appropriate to your
installation, and replace the
compartment cover.
7. Using the Wall Mounting
Bracket, mark and drill the
holes for the wall anchors.
(Figure 4)
8. Install the screws through the
Wall Mounting Bracket and
into the anchors.
! NOTE: Ensure that the flat
side of the Wall Mounting Bracket
is against the wall and the screws
are installed so that they rest
against the extended portion of
the hole. The space will allow
screws to sit in the mounting
holes correctly.
9. Slide the unit onto the screws.
10. Plug the unit into the wall
receptacle.
Receptacle Cover Wall
Mount Installation
1. Determine an appropriate lo-
cation to mount the Multi-zone
Wi-Fi controller, over a 120V
wall receptacle and in the vi-
cinity of a Wi-Fi router with an
active internet connect.
2. Remove the Multi-zone Wi-Fi
Controller and installation
hardware from its package.
3. Remove the plastic tab on the
back of the unit and synchro-
nize all heaters with the unit.
(Figure 3)
4. Using the Receptacle Cover,
mark and drill the holes for the
wall anchors, ensure that the
receptacle is fully concealed.
(Figure 5)
5. Route the USB cord through
the center hole in the Recep-
tacle Cover.
6. Plug the USB cord into the
power adapter and then into
wall receptacle.
7. Install the screws through the
Receptacle Cover and into the
anchors.
Figure 5
Receptacle
Cover
9