Disarming The System; Disarming From Stay Mode; Disarming From Away Mode - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide
7 The system arms and shows the Exit Delay counting
down. When the Exit Delay expires, the system is fully
armed in the Away mode.
NOTE: When the system is armed in the Away mode,
beeps sound during the Exit Delay (these beeps
become faster during the last 10 seconds).

DISARMING THE SYSTEM

To stop the Control Panel from triggering burglary alarms,
the system needs to be disarmed. Disarming turns off the
burglary detection part of the system for sensors that are
not 24-hour sensors. Disarming also stops any type of
alarm in process.
Disarm the system from Stay mode before exiting the
premises. The system should be disarmed from Away
mode before or while entering the premises. When
disarming from the Control Panel or wireless keypad, enter
a valid user code. A wireless key fob can also be used to
disarm the system. Entering a user code is not required
when disarming with a wireless key fob.
An important feature of the Control Panel is its ability to
warn you if an alarm has occurred while you were away.
If an alarm was triggered while the system was armed,
the alarm siren runs for a preset length of time then
stops. When you enter to disarm the system, instead of
sounding the normal Entry Delay beeps, the Control Panel
sounds repeated fast beeps to warn you that an alarm has
occurred while you were away.
When you enter your home to disarm the
system, if you hear fast repeated beeps instead
of the normal Entry Delay beeps, use Extreme
Caution! An intruder may still be present inside
the building! Wait outside and use a Cell Phone
to call law enforcement for assistance.

Disarming from Stay Mode

Disarm the system from Stay mode before exiting the
premises.
1 At the Home screen, tap
2 At the Security screen or the Menu screen, tap Disarm.
This action displays the Disarm Code screen.
3 The left side of the screen shows any events that have
occurred while the system was armed.
4 Enter a valid user code to disarm the system.
● In the event you tap the wrong key, the
erases the entire entry.
● Tap if you decide to not disarm the system at
this time.

Disarming from Away Mode

The system should be disarmed from Away mode while
entering the premises.
1 Enter the premises through a designated Entry Delay
sensor-protected door.
2 The Disarm Code screen displays on the Control Panel
and the Entry Delay beeps sound. The left side of the
screen shows events that have occurred while the
system was armed.
3 Enter a valid user code to disarm the system.
● In case you tap the wrong key, the
erases the entire entry.
15
Burglary Protection
for Silent Control.
button
Copyright © 2019 Nortek Security & Control
button