Adjusting The Brightness/Volume - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide
To setup the chime options individually for each sensor:
1 At the Home screen, tap Security.
2 At the Security screen, tap Menu.
NOTE: Select or clear the Chime and Voice check boxes
to turn the system chimes and voice announcements ON or
OFF (except for alarm voice messages).
3 At the Menu screen, tap Toolbox.
4 Enter the master user code to gain access to the
Toolbox.
5 At the Toolbox (1 of 3) screen, tap Chime Setup. The
Chime Setup screen displays each of the installed
sensors that can chime and the option currently set for
the sensor.
To change the sensor's chime options, tap the sensor
button.
TIP: There are 14 chime options for each sensor.
Chime Option
1 Disabled
2 Voice Only
3 Ding-dong #1
4 Ding-dong with Voice #1
5 Ding-dong #2
6 Ding-dong with Voice #2
7 Ding-dong #3
8 Ding-dong with Voice #3
9 Ding-ding
10 Ding-ding with Voice
11 Chime #1
12 Chime with Voice #1
13 Chime #2
14 Chime with Voice #2
6 Check the option that you want for the sensor, then tap
OK.
7 When you are finished, tap Back.

ADJUSTING THE BRIGHTNESS/VOLUME

You can adjust the brightness of the Control Panel's display
and the volume of the system's speaker that is best suited
to your installed system.
To set the brightness and volume:
1 At the Home screen, tap Security.
2 At the Security screen, tap Menu.
3 At the Menu screen, tap Toolbox.
4 Enter the master user code to gain access to the
Toolbox.
31
System Toolbox
Copyright © 2019 Nortek Security & Control