Wireless Keypad Emergency Keys; Exit Delay Restart; Cancel Display; Cancel Time - Nortek Security & Control 2GIG e Serie Guia Del Usuario

GC2e Wireless Security System | User Guide

Wireless Keypad Emergency Keys

Each standard wireless keypad has Fire and Police
emergency buttons that can be enabled or disabled for
each keypad. Refer to the table below for options set for
your keypads:
Option
Emergency Keys Enabled
Emergency Keys Disabled

Exit Delay Restart

The Exit Delay Restart option will extend the Exit Delay one
time if you need to re-enter the premises. When the system
is armed in the Away mode or Stay mode, the Exit Delay
gives you time to leave without setting off the alarm. With
the Exit Delay Restart option, re-entering the premises after
you have left, but before the Exit Delay timer expires, will
restart the Exit Delay timer, giving you the full length of time
to leave again. The restart option only works once, each
time the system is armed.
● Off
● On

Cancel Display

A "cancel" message will be sent to the Central Station if the
system is disarmed within a preset period of time after an
alarm is triggered. The system can be set to display that a
cancel report was sent, or for higher security, the system
can be set not to display the cancel message.
● Off
● On

Cancel Time

To limit responses to false alarms, a "cancel" message will
be sent to the Central Station if the system is disarmed
within a preset period of time after an alarm is triggered.
The alarm report is always sent, but it will be followed by
a cancel report if you disarm the system within the preset
time.
This option helps the Central Station to determine whether
you accidentally caused the alarm or if the alarm was
caused by an intruder. It also lets the Central Station know
that you have returned to the premises. Even if a cancel
message is sent, the Central Station will verify the alarm
and possibly dispatch help. The cancel message may be
processed by the Central Station at a later time depending
on system programming.
● Five Minutes is the default, or _______ Minutes

Dialer Delay

If an alarm occurs, the system will delay dialing for a short
time to allow you to disarm the system in case the alarm
was accidentally tripped. The dialer delay reduces nuisance
traffic to the Central Station and can prevent receiving fines
that many cities impose when police respond to a false
alarm. Your installer also can program the system for no
1 2 3 4
dialer delay.
NOTE: The dialer delay is also known as the abort window.
It gives you time to disarm, but doesn't delay the siren from
sounding. Disarming during the abort window can display a
cancel message depending on the Cancel Display setting
(see "Cancel Display").
● 30 Seconds is the default, or ______ Seconds.

2-Way Voice

The system can connect with a Central Station operator
so they can converse with people on the premises after an
alarm. The 2-way voice option allows communication to
and from the Control Panel and the Central Station. 2-way
voice communications will occur after the system has made
its alarm report. Your installer sets which sensors can
trigger the 2-way voice option.
● Disabled
● Stay on line
● Stay on line, including fire and CO alarms.
36
System Toolbox
Copyright © 2019 Nortek Security & Control