Protective Measures; Maintenance And Cleaning; Cleaning The Unit - Oase LUNAQUA Classic Instrucciones De Uso

Installation
The unit is supplied fully assembled as a complete set with a transformer and one or three LED spotlights, including
bulbs.
Installation (B-C)
− The foot can either be stood on the ground or bolted to a firm base or load bearing wall (B).
− Position the unit in such a way that it does not present a hazard to anybody.
− Adjust the tilt of the light (C, 1) and fix it at this angle with the screw connection (C, 4).
− Connect the plug of the spotlight connection cable to the socket on the transformer and tighten the union nut (C, 5)
hand-tight.
Start-up
Attention! Sensitive electrical components.
Possible consequence: The unit will be destroyed.
Protective measure: Do not connect the unit to a dimmable power supply.
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.

Protective measures:

− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
Switching on: Insert the power plug of the transformer into the socket.
− Check the function of the spotlights.
Switching off: Disconnect the transformer power plug.
Replacing the bulb (D)
− Unscrew the threaded ring (6).
− Remove the glass pane (7) and O ring (8) and check for damage. Replace if necessary.
− Remove the defective bulb (9) from the housing (1).
− Insert a new bulb (do not touch with your hands, use a cloth or similar).
Only use original bulbs from OASE. Light bulb rating: max. 1 W.
− Reassemble the unit in the reverse order. Ensure that the O ring (8) is correctly positioned.
− Reconnect to the power supply and check the function.

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
− Ensure that no moisture can enter the unit.

Cleaning the unit

If necessary, clean the unit with clear water using a soft brush.
4
23868-09-13_GA_LunAqua Classic L4 4 13.09.2013 10:36:23