i.safe MOBILE IS910.1 Manual Del Usuario página 5

FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately .
Measures must be taken to prevent any accidental restarting of the device .
The safety of the device may be compromised, if for example:
Malfunctions occur .
The housing of the device shows damage .
The device has been subjected to excessive loads .
The device has been stored improperly .
Markings or labels on the device are illegible .
We recommend that a device displaying errors or in which an error is suspected be
sent back to i.safe MOBILE GmbH to be checked .
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certificate .
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed .
To ensure the IP-protection, it has to be ensured that the all gaskets are present and
functional . IP protection is not guaranteed anymore if gaps are visible .
The device may only be charged outside ex-hazardous areas using the i.safe
PROTECTOR 2.0 or i.safe PROTECTOR 3.0 USB-cable or other equipment approved
by i.safe MOBILE GmbH .
Physical connections to other equipment are only allowed outside ex-hazardous
areas using the i.safe PROTECTOR 2.0 or i.safe PROTECTOR 3.0 USB-cable or other
equipment approved by i.safe MOBILE GmbH .
The device may be charged only at ambient temperatures in between +5°C . . . +35°C .
The device must not be exposed to abrasive acids or bases .
The device must not be taken into zones 0 or 20 .
Only accessories approved by i.safe MOBILE GmbH may be used .
In case the device has a hand strap, it is not allowed to do the adjustment of the hand
strap in ex-hazardous areas .
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects . Dust particles and nails may
scratch the screen . Please maintain the screen clean . Remove dust on the screen with
a soft cloth gently, and do not scratch the screen .
Do not put the device in environments with excessive temperatures, as this could lead
to heating of the battery, resulting in fire or explosion .
Do not charge the device near any flammable or explosive substances .
Charge the device under dry indoor conditions only .
Do not charge the device in environments with much dust or humidity .
EN 5