Iso Mount Radio Provision With Pocket - Metra 95-2009 Instrucciones De Instalación

1. Cut radio housing support bars and remove.
(Figure A)
2. Slide the radio housing brackets onto the pocket
and secure with the supplied (2) #8 3/8" screws.
(Figure B)
3. Mount the ISO Brackets to the head unit with the
screws supplied with the unit. (Figure C)
4. Slide the head unit into the radio opening until the
side clips engage. (Figure D)
(Figure A)
Kit Assembly 99-2009

ISO mount radio provision with pocket

5. Snap the trim plate into the single DIN radio
housing. (Figure D)
Note: For the Buick LeSabre, Oldsmobile Aurora
and the Pontiac Bonneville the (3) speed clips
and screws provided with the kit will need to be
installed into the sub dash where the screw holes
line up on the kit.
6. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
(Figure B) (Figure C)
29
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the unit for
proper operation.
7. Reassemble dash in reverse order
of disassembly.
(Figure D)