Mounting Locations; Remote - Rockford Fosgate RAV Serie Instalación Y Funcionamiento

I
NSTALLATION

MOUNTING LOCATIONS

Engine Compartment
Never mount the source or tuner unit in the engine compartment. Mounting the source or tuner unit in
the engine compartment will void your warranty.
SOURCE UNIT
The mounting position of your source unit will have a great effect on the performance of your in-dash
CD/DVD Player.The source unit can be installed in a wide range of operating locations. However, care
should be taken to ensure optimum performance.
NOTE: Make sure there is adequate room for the motorized screen to move into a viewing position.
Instrument Panel
Mounting the source unit in the instrument panel provides optimum access.The source unit should be
securely mounted using the "Standard Mount" or "ISO-DIN Mount" method to ensure optimum CD/DVD
Player performance.
Center Console
Mounting the source unit in the center console provides optimum access. Be sure the installation does not
interfere with the operation of the gear shift or parking brake.
Glove Box
Mounting the source unit in the glove box is adequate, but does not provide easy access. Glove box
mounting should only be done if "Instrument Panel" or "Center Console," mounting is not acceptable (i.e.,
maintaining integrity of older vehicles with metal dashboards.)
Under Dash
Mounting the source unit under the dash is adequate, but does not provide easy access. Under dash
mounting should only be done if "Instrument Panel," "Center Console" or "Glove Box" mounting is not
acceptable. Mount the source unit off to the side of the driver's area to reduce interference with the
parking brake, gear shift, or operating pedals.
NOTE: The source unit should have a mounting angle within ±20° from horizontal.
TUNER UNIT
Mount the tuner unit in a location that will allow easy access for the various connections. Unusually under
a seat, behind the console or in a console cavity. Allow for adequate ventilation around the tuner unit.
Never mount the tuner unit in a location where it may impair the controls of the vehicle such as the
brake, clutch, parking brake, shift lever, etc.

REMOTE

Install the clip mount for the remote using two (2) screws or double-sided tape in a location that allows
easy access.
CAUTION:To prevent accidents, never place the remote where it will impair the safe
operation of a vehicle.
Battery Installation
1. Remove the battery cover on the back of the remote.
2 Install two (2) AAA batteries with the polarities correct as shown by the diagram inside the battery
compartment of the remote.
6