Chauvet Professional EPIX STRIP 2.0 Guía De Referencia Rápida página 7

EN
Series Attachment Instructions
The ÉPIX™ Strip 2.0 can be attached in an end-to-end formation to create a strip up to 4
meters long from just one rigging point.
Do not connect more than a total of 4 strips in a row when hanging vertically.
1. Loosen the safety loop and fastening knob.
2. Slide the connecting bracket out till it stops and tighten the safety loop.
3. Slide the 2
knob, then attach the safety cable.
1
Fastening Knob
Be sure to install the safety cable last when attaching the products in series.
Page 7
nd
Epix™ Strip into the connecting bracket and tighten the fastening
Safety Loop
3
ÉPIX™ Strip 2.0 QRG
2
ÉPIX™ Strip 2.0 QRG Rev. 2