Connecting To A Stereo Speaker Output - Monoprice PID 14567 Manual De Usuario

To make this connection you will need a stereo RCA patch cable of the appropriate length.
1. Insert the black/negative side of one end of the cable into the black/negative Low
Level Input RCA jack on the back of the subwoofer.
2. Insert the red/positive side of one end of the cable into the red/positive Low Level
Input RCA jack on the back of the subwoofer.
3. Insert the black/negative side of the other end of the cable into the black/negative
pre-amplifier RCA jack on the back of the amplifier/receiver.
4. Insert the red/positive side of the other end of the cable into the red/positive pre-
amplifier RCA jack on the back of the amplifier/receiver.

Connecting to a Stereo Speaker Output

If your amplifier/receiver lacks both a dedicated subwoofer output and pre-amp outputs,
you can still make a connection using speaker level inputs on the subwoofer. To make this
connection will need two equal lengths of two-conductor speaker wire.
1. Connect the black/negative side of one speaker wire to the left channel
black/negative High Level Input 5-way binding post on the back of the subwoofer.
2. Connect the red/positive side of the wire to the left channel red/positive High Level
Input 5-way binding post on the back of the subwoofer.
3. Connect the black/negative side of the other end of the speaker wire to the
black/negative left channel output for the Front/Main speakers on the back of the
amp. This can be connected in parallel to the actual front main speakers.
4. Connect the red/positive side of that end of the wire to the red/positive left
channel output for the Front/Main speakers on the back of the amp.
5. Repeat steps 1-4 for the right channel connection.
6. Visually inspect the connections at each end to verify correct polarity and the
absence of any stray wire strands.
Note that the 5-way binding posts have protective plugs inserted into the end. If
you are using banana plugs, remove these plugs and put them in a safe place for
future use. Otherwise, you can leave them in place.
10