Setup; Subwoofer Settings - Monoprice PID 14567 Manual De Usuario

SETUP

Once all connections have been made and inspected, plug in and power on all equipment,
including the subwoofer.

Subwoofer Settings

Auto Power: The amplifier features a power saving mode, which will automatically put
the amplifier into standby mode after about 22 minutes of inactivity, then will
automatically power on when an audio signal is detected. Use the POWER and AUTO
switches to determine the mode of operation, as outlined below:
Mode
ALWAYS OFF
STANDBY
AUTO ON
ALWAYS ON
Note: If you will be away, or if the subwoofer will go unused for a lengthy period, set
the power switch to the OFF position.
Frequency: The Frequency knob allows you to adjust the frequency of the low pass
filter, which acts as a crossover network between the subwoofer and satellite/center
channel speakers. This setting determines how well the bass from the subwoofer
blends with the mids and highs from the satellite and center channel speakers.
Refer to the owner's manual for your satellite/center channel speakers to find the low
end of the frequency response. A good starting point therefore is to set the Frequency
knob to a position that represents that level, then adjust it slightly up or down
according to how it sounds.
POWER Switch
OFF
ON
ON
ON
11
AUTO Switch
N/A
ON
ON
OFF
LED
Off
Red
Green
Green