Defects Finding Guide - Beko HM130520B Manual De Instrucciones

EN
Inside cleaning
Before starting the cleaning, unplug the
appliance from the mains.
 It is advisable to clean the appliance when
you defrost it.
 Wash the inside with lukewarm water
where you add some neutral detergent. Do
not use soap, gasoline or acetone which can
leave a strong odour.
 Wipe with a wet sponge and dry with a soft
cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.
Outside cleaning
 Clean the outside of the cooler by means of
a sponge soaked in soapy warm water, wipe
with a soft cloth and dry.
 The cleaning of the outside part of the
refrigerating circuit (motorcompressor,
condenser, connection tubes) will be done
with a soft brush or with the vacuum-cleaner.
During this operation, please take care not to
distort the tubes or detach the cables.
Do not use scouring or abrasive materials!
 After having finished the cleaning, replace
the accessories at their places and plug in the
appliance.
 The tray will be cleaned every time when it
is required.
Attention: The cleaning will be done with the
tray detached from the appliance.
After having finished the cleaning, put the
accessories back to their places.

Defects finding guide

The appliance does not work.
There is a power failure.

The plug of the supply cord is not inserted

well into the socket.
 The fuse is blown.
The thermostat is in „OFF" position.

The temperatures are not low enough (red
LED on).
The food prevents the door closing.

The appliance was not placed correctly.

The appliance is placed too close to a heat

source.
The thermostat knob is not in the correct

position.
Excessive ice build-up in freezer mode.
The door was not closed properly.

The inside lighting does not work
The lamp is blown. Unplug the appliance

from the mains, take out the lamp and replace
it with a new one.
The following are not defects.
Possible noddings and cracks coming from

the product: circulation of the refrigerant in the
system.
Noises during operation
In order to keep the temperature at the value
you have adjusted, the compressor of the
appliance starts periodically.
The noises which can be heard in such
situation are normal.
They are reduced as soon as the appliance
reaches the operation temperature.
The humming noise is made by the
compressor. It can become a little stronger
when the compressor starts.
The bubbling and gurgling noises coming from
the refrigerant circulating in the pipes of the
appliance, are normal operating noises.
Warning!
Never try to repair yourself the appliance or its
electric components. Any repair made by an
unauthorised person is dangerous for the user
and can result in the warranty cancellation.
7
Instruction for use