Allen-Bradley MicroLogix 1000 Manual Del Usuario página 8

Important: If you use wires without lugs, make sure the wires are securely
captured by the pressure plate. This is particularly important at the
four end terminal positions where the pressure plate does not touch
the outside wall.
Important: Be careful when stripping wires. Wire fragments that fall into the
controller could cause damage. Remove the protective wrap after
wiring your controller. Failure to remove the wrap may cause the
controller to overheat.
Important:
provides a low impedance path between electrical circuits and earth
for non-safety purposes, such as noise immunity improvement.
This symbol denotes a functional earth ground terminal which
Installation Instructions
MicroLogix 1000 Programmable
Controllers
Protective
Wrap
20148
20145
7