Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Nissan Sentra 2000-2006
99-7414 & 99-7414G
KIT FEATURES
• ISO DIN radio provision
• 99-7414 = Black
• 99-7414G = Gray
KIT COMPONENTS
• A) Radio trim panel
A
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-7550 • 70-7551
Antenna Adapter: • Not required
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver • Small flat blade screwdriver
METRA. The World's best kits.
Installation instructions for part 99-7414
™
metraonline.com
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DIN radio provision......................................... 3
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
Publicidad
Tabla de contenido
Manuales relacionados para Metra 99-7414
Resumen de contenidos para Metra 99-7414
- Página 1 • 99-7414G = Gray KIT COMPONENTS • A) Radio trim panel CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING & ANTENNA CONNECTIONS (sold separately) Dealership for more information.
-
Página 2: Dash Disassembly
99-7414 Dash Disassembly 1. Open the storage compartment 4. Remove (2) screws securing the 101.1 climate control trim panel to the above the radio, and pull out on factory brackets. (Figure D) the lip of the compartment to remove the compartment/AC vent 5. -
Página 3: Kit Assembly
4. Place the completed assembly the proper mating adapter from 2. Slide the radio between the factory on the front of the radio/climate- Metra or AXXESS. Re-connect the pocket/climate-control assembly control/pocket assembly, and then negative battery terminal and test removed in disassembly, and then the radio for proper operation . -
Página 4: Important
Installation instructions for part 99-7414 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated. -
Página 5: Características Del Kit
Instrucciones de instalación para la pieza 99-7414 Indice Nissan Sentra 2000-2006 99-7414 y 99-7414G Desmontaje Dash ........... 2 Ensamble del kit – Provisión de radio ISO DIN ........3 CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DIN • 99-7414 = Negro •... - Página 6 99-7414 Desmontaje Dash Abra el compartimiento de almacenamiento Quite los (2) tornillos que sujetan el panel 101.1 de la moldura de control del clima a los de la parte de arriba del radio y jale hacia soportes de fábrica. (Figura D)
-
Página 7: Ensamble Del Kit
1. Quite la manga de metal DIN y en el tablero. Metra recomienda quitó durante el desensamble y el panel el anillo de moldura del radio de que use adaptadores adecuados de la moldura del radio. -
Página 8: Importante
Instrucciones de instalación para la pieza 99-7414 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...