Kit Assembly - Metra 99-7414 Instrucciones De Instalación

ISO DIN radio provision
1. Remove the metal DIN sleeve and
trim ring from the aftermarket
radio.
2. Slide the radio between the factory
pocket/climate-control assembly
removed in disassembly, and then
attach the radio to the assembly
using the screws supplied with the
radio. (Figure A)
(SHOWN WITH ALL TRIM PANELS OFF)
(shown with all trim panels off)
(Figure A)
3. Snap the factory climate control
trim panel removed in disassembly
and radio trim panel together.
(Figure B)
4. Place the completed assembly
on the front of the radio/climate-
control/pocket assembly, and then
attach the two assemblies together
using the screws removed during
disassembly. (Figure C)
(Figure B)
99-7414

Kit Assembly

5. Locate the factory wiring harness
and antenna connector in the
dash and complete all necessary
connections to the radio and climate
controls. Metra recommends using
the proper mating adapter from
Metra or AXXESS. Re-connect the
negative battery terminal and test
the radio for proper operation .
6. Reassemble the dash in reverse
order of disassembly.
(Figure C)
3