Dash Disassembly - Metra 99-7414 Instrucciones De Instalación

1. Open the storage compartment
above the radio, and pull out on
the lip of the compartment to
remove the compartment/AC vent
assembly. (Figure A)
2. Below the climate control, unclip
and remove the trim panel around
the pocket. (Figure B)
3. Remove (4) screws securing the
radio/climate-control/pocket
assembly (2 on top, 2 on bottom),
then unplug and remove the entire
assembly. (Figure C)
(Figure A)
101.1
2 3 4
1

Dash Disassembly

101.1
3 4
2
1
(Figure B)
101.1
3 4
2
1
(Figure C)
99-7414
4. Remove (2) screws securing the
climate control trim panel to the
factory brackets. (Figure D)
5. Remove (4) screws securing the radio
to the factory brackets. (Figure E)
6. Remove the radio and climate
control trim panel from the pocket/
climate-control assembly. (Figure E)
Note: Retain the pocket/climate-
control assembly to be reused
during kit assembly.
7. Unsnap and remove the climate
control trim panel from the radio.
(Figure F)
Note: Retain the climate control trim
panel to be reused during kit assembly .
Continued to kit assembly
101.1
3 4
2
1
(Figure D)
2
(Figure E)
(Figure F)