Metra 99-9008 Instrucciones De Instalación

Volkswagen beetle 1998-2010

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Volkswagen Beetle 1998-2010
KIT FEATURES
• ISO DIN radio provision
• DIN radio provision
*
Aftermarket radios are equipped with a trim ring surrounding the face of
the radio. Since some installers prefer the trim ring equipped with the radio
(DIN) and others do not (ISO DIN), this kit was designed to allow the installer
to choose.
KIT COMPONENTS
• A) ISO DIN housing • B) ISO DIN trim plate • C) ISO DIN brackets • D) DIN trim plate
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • 70-1784
Antenna Adapter: • 40-VW54
TOOLS REQUIRED
• 86-9001 radio removal keys • Torx T-10 driver
METRA. The World's best kits.
Installation instructions for part 99-9008
99-9008
C
metraonline.com
D
Table of Contents
Dash Disassembly ................................................. 2
Kit Assembly
– ISO DIN radio provision......................................... 3
– DIN radio provision
............................................ 4
CAUTION!
Metra recommends disconnecting the negative bat -
tery terminal before beginning any installation, unless the vehicle
manufacturer recommends against so. Please check with your local
Dealership for more information. All accessories, switches, climate
controls panels, and especially air bag indicator lights must be con -
nected before reconnecting the battery or cycling the ignition. Also,
do not remove the factory radio with the key in the on position, or the
vehicle running. It would be best to remove the key from the ignition
and then wait a few seconds before removing the factory radio.
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Metra 99-9008

  • Página 1 • A) ISO DIN housing • B) ISO DIN trim plate • C) ISO DIN brackets • D) DIN trim plate CAUTION! Metra recommends disconnecting the negative bat - tery terminal before beginning any installation, unless the vehicle manufacturer recommends against so. Please check with your local WIRING &...
  • Página 2: Dash Disassembly

    99-9008 Dash Disassembly 1. Insert the long end of the 86-9001 radio removal tool into the slots in the factory radio (flat sides pointing out), and then pull the radio out. Disconnect all connectors and then remove the radio. (Figure A) 2.
  • Página 3: Kit Assembly

    3. Locate the factory wiring harness and antenna connector in the dash and make all necessary connections to the radio. Metra recommends using the proper mating adapters from Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio...
  • Página 4: Important

    Metra recommends (Figure A) using the proper mating adapters from Metra and/or AXXESS. Re-connect the negative battery terminal and test the radio for proper operation. NOWLEDGE IS...
  • Página 5: Características Del Kit

    Instrucciones de instalación para la pieza 99-9008 Volkswagen Beetle 1998-2010 Indice 99-9008 Desmontaje del tablero ......... 2 Ensamble del kit CARACTERÍSTICAS DEL KIT • Provisión de radio ISO DIN – Provisión de radio ISO DIN ........3 • Provisión de radio DIN –...
  • Página 6: Desmontaje Del Tablero

    99-9008 Desmontaje del tablero 1. Inserte los extremos largos de la herramienta de remoción de radio 86-9001 en las ranuras del radio de fábrica (con los lados planos orientados hacia afuera) y luego jale el radio para quitarlo. Desconecte todos los conectores y luego quite el radio.
  • Página 7: Ensamble Del Kit

    3. Localice el arnés de cableado de fábrica y el conector de la antena en el tablero y haga todas las conexiones necesarias al radio y los controles del clima. Metra recomienda que use adaptadores adecuados de acoplamiento de (Figura B) (Figura D) Metra y/o de AXXESS.
  • Página 8: Importante

    (Figura A) controles del clima. Metra recomienda que use adaptadores adecuados de acoplamiento EL CONOCIMIENTO ES PODER de Metra y/o de AXXESS. Vuelva a conectar la Mejore sus habilidades de instalación y NOWLEDGE IS OWER fabricación inscribiéndose en la escuela de Enhance your installation and fabrication skills by terminal negativa de la batería y pruebe el radio...

Tabla de contenido