Important - Metra 99-9008 Instrucciones De Instalación

DIN radio provision
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Attach the DIN trim plate in the radio cavity, then
slide the sleeve through the DIN trim plate, and
then secure by bending the metal locking tabs
down. (Figure A)
3. Locate the factory wiring harness and antenna
connector in the dash and make all necessary
connections to the radio. Metra recommends
using the proper mating adapters from Metra
and/or AXXESS. Re-connect the negative battery
terminal and test the radio for proper operation.
4. Slide the radio into the sleeve until it clicks in.
(Figure B)
METRA. The World's best kits.
Installation instructions for part 99-9008
Kit Assembly
(Figure A)
(Figure B)
™
metraonline.com

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER