Kit Assembly - Metra 95-7331 Instrucciones De Instalación

ISO DDIN radio provision
1. Snap the switches removed in dash
disassembly into the radio housing, in
the same location as removed from the
factory radio. (Figure A)
2. Snap the radio brackets to the inside
edge of the radio housing. (Figure B)
3. Slide the radio into the completed assembly
from the rear, and then secure it to the
assembly using the screws supplied with
the radio. (Figure C)
(Figure A)
METRA. The World's best kits.
Installation instructions for part 95-7331

Kit Assembly

(Figure B)
(Figure C)
™
metraonline.com
IMPORTANT
If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2015 METRA ELECTRONICS CORPORATION
P
OWER