Dash Disassembly; Kit Preparation - Metra 99-7424 Instrucciones De Instalación

Dash Disassembly

1. Unclip the entire dash panel including
the radio and climate controls. Unplug
and remove the panel. (Figure A)
2. Remove (4) Phillips screws securing
the radio chassis. Unplug and remove
the chassis. (Figure B)
3. Remove (4) T-10 Torx screws securing
the climate controls to the dash
panel and remove the controls from
the panel. (Retain the screws and
climate controls for re-use during kit
preparation.) (Figure C)
4. Remove (2) T10 Torx screws securing
the passenger air bag status light
assembly to the dash panel and
remove the light from the panel.
(Retain the screws and light for re-use
during kit preparation.) (Figure C)
Note: The small round Airbag sticker
also needs to be removed from the
factory panel and placed onto the
99-7424 radio housing panel. (A
round piece of double-sided tape is
provided in case the factory sticker
is not strong enough.) (Figure C)
Continue to kit preparation
(Figure A)
(Figure B)
(Figure C)
99-7424

Kit Preparation

1. Attach the climate controls to
the trim panel using the factory
hardware removed during the dash
disassembly. (Figure A)
2. Attach the passenger air bag
status light assembly to the
trim panel using the factory
hardware removed during the dash
disassembly. (Figure B)
Also, apply to air bag button
the small round airbag sticker
previously. (Figure B)
3. Attach the (9) panel clips in the
same position as the factory radio
trim panel.
Note: If clips are not provided
then please remove the factory
clips and re-use them.
Continue to kit assembly
2
(Figure A)
(Figure B)