Olympia CM 811 Guía De Referencia Rápida página 35

Quick Reference
Using the clerk system without password (default)
This only works when the clerk system is activated (see above). If no password has been programmed for the clerk (de-
fault 000), he/she can only log on using their clerk number.
Logging on:
Set the key to REG.
Enter the single digit clerk number
and conclude by pressing
Up to 8 clerks can be registered in the system.
Logging off:
Set the key to REG.
0
Press
and conclude by pressing
Clerk system with password
It is possible to protect clerk log on codes by means of a password.
Clerks then log on using their clerk number and associated password.
The password is a 3-digit code (000 to 999).
The clerk number and password thus comprise the 4-digit clerk code.
Clerk code structure
1 2 3 4
3-digit password (000-999)
clerk number (1-8)
Logging on:
Set the key to REG.
Enter the single digit clerk number,
enter the 3-digit password directly following and
conclude by pressing
If an incorrect password is entered, error message
Clerks remain logged on until they log off properly (see above).
Programming clerk passwords
Example: Programming the passwords for clerk no. 1 (password: 456) and clerk no. 2 (password: 987).
Set the key to PRG
Activate Programming mode for
clerk passwords:
4
Press
Confirm by pressing
Olympia 8.2005
CM 811/812 Cash Register
Q
.
Q
.
Example: Clerk no. 1 logs on with his password "456" (clerk code: 1456).
Q
.
6 times
q
Example: Cashier with clerk number 6 logs on.
Input
6
Example: A cashier logs off.
Input
0
4-digit clerk code
Input
1
456
E
appears in the display.
Input
444444
Page 13
Quick Reference
Display Confirm by pressing
Q
6
Display Confirm by pressing
Q
0
Display Confirm by pressing
1
Q
14,56
Display Confirm by pressing
444444
All Rights Reserved
q