GE ASM14 Serie Manual De Instrucciones página 13

Window Installation Instructions
[] INSTALL THE CASE
IN THE WINDOW
[] Cut the window sash seal to the window
width and stick the adhesive side to the
bottom of the sash.
Window sill
Window sash seal
[] Thread two type C bolts into the support
brackets,
Slide the case into the window and lower
the window behind the top mounting rail.
Position the brackets on the case bottom so
they will be near the outermost point on the
window sill. Attach the support brackets to
each side of the case bottom using 4 type A
screws on each side. The case should be
slightly tilted to the outside, Use a level;
about a 1/2 bubble will be the correct case
slant to the outside, Adjust the leveling bolts
to touch the sill,
Window sill -----__
U
,Type A screws
_iype C bolts
-& CAUTION: Ifthesill
s upport
bolts do not contact the window sill,
or if you have a window without a sill,
you must order accessory kit RAK87 to
properly install this air conditioner. Call
800.626.2002 or visit ge.com.
[] INSTALL THE CASE
IN THE WINDOW (cont.)
[] Locate the 8 screw holes along the bottom
front edge of the case, Center the case, side-
to-side, in the window and mount it to the
window sill using 5 type B screws staggered
in the front and back rows if possible,
Top mounting rail
Type B
screws
Type B screws
Type B
screws
[] Extend the left and right accordion panels to
the vertical window sashes and attach with
4 type B screws.
[] INSTALL THE SECURITY
BRACKET AND THE FOAM TOP
WINDOW GASKET
[] Attach the security bracket with a type B
screw.
[] Cut the foam top window gasket to the
window width.
[] Stuff the foam between the glass and the
window to prevent air and insects from
getting into the room.
/
13