Starting Up The Device - Weller WR 3M Manual Del Usuario

WR 3M
WARNING!
USB port
The control unit is equipped with a mini USB port (25). For the
purpose of using the USB port, Weller software is available on a CD
with which you
− can carry out a software update ("Firmware Updater") on your
control unit and
− can remote-control the control unit and graphically display, store
and print temperature curves ("Monitor Software").
Equipotential bonding
4 variants are possible through connecting the 3.5 mm pawl
socket (28) differently:
− Hard earthed/grounded: without connector (delivery status)
− Equipotential bonding: with connector, bonding lineat central
contact
− Floating: with connector
− Soft earthed/grounded: with connector and soldered resistor.
Earthing/grounding via the selected resistor

5 Starting up the device

Risk of injury due to incorrectly connected
vacuum hose.
If the vacuum hose is incorrectly connected, hot air and liquid
solder can escape when the unsoldering bit is actuated and
cause injuries.
Never connect the vacuum hose to the "Air" nipple!
1. Carefully unpack the device.
2. Connect the soldering tools as follows:
- Connect the hot-air pencil (HAP) with air hose to "Air"
nipple (15) and insert with the attachment plug in connection
socket ┌ 1 ┐, ┌ 2 ┐ or ┌ 3 ┐ (16) of the repair station and lock by
turning clockwise slightly. The HAP 1 hot-air pencil can only be
connected with the air-hose adapter.
Note If you are using an HAP 200, this can only be connected to
channel 1! The maximum output power is limited to 360 watts.
- Connect the unsoldering tool with vacuum hose to "Vac"
nipple (14) and insert with the attachment plug in connection
socket ┌ 1 ┐, ┌ 2 ┐ or ┌ 3 ┐ (16) of the repair station and lock by
turning clockwise slightly.
- Insert the soldering tool with attachment plug in connection
socket ┌ 1 ┐, ┌ 2 ┐ or ┌ 3 ┐ (16) of the repair station and lock by
turning clockwise slightly.
- Two pick-up tools (WRK, WVP) can be connected with the
vacuum hose to the two pick-up nipples (13), where only the
right nipple is active. You can switch to the other nipple by
rotating 180°.
3. Place the soldering tools in the safety holder.
7-22