GE JVB37 Manual Del Propietario E Instrucciones De Instalación página 2

IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
PLEASE NOTE: The downdraft vent system you have purchased was designed to be used
with GE, GE Profile and GE Profile Performance cooktops listed in this manual.
WARNING!
For your safety, the information in this manual must be followed to minimize the risk of fire or
explosion, electric shock, or to prevent property damage, personal injury, or loss of life.
WARNING: TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended
by the manufacturer. If you have questions,
contact the manufacturer.
B. Before servicing or cleaning unit, switch power
off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag,
to the service panel.
CAUTION:
Do not use to exhaust hazardous or explosive materials
and vapors.
I
Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
SAFETY PRECAUTIONS
WARNING!
I
Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
I
Always turn hood ON when cooking at high heat.
I
Do not flame foods on the cooktop. If you do
flame foods under the hood, turn the fan on.
2
For general ventilating use only.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
I
Sufficient air is needed for proper combustion
and exhausting of gases through the flue
(chimney) of fuel-burning equipment to prevent
back drafting. Follow the heating equipment
manufacturer's guideline and safety standards
such as those published by the National Fire
Protection Association (NFPA), and the
American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE),
and the local code authorities.
I
When cutting or drilling into wall or ceiling,
do not damage electrical wiring and other
hidden utilities.
I
Ducted fans must always be vented to the
outdoors.
I
To reduce the risk of fire, use only metal
ductwork.
I
PVC sewer pipe can be used as duct under
concrete slab if allowed by local code board.
I
This unit must be grounded.
I
Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan or filter.
I
Use proper pan size. Always use cookware
appropriate for the size of the surface element.