Speed Adjustment; Technical Service; Replacement Parts Information - Campbell Hausfeld CL0060 Manual Del Usuario

Operation (Continued)
2. Set tool lever in the reverse position.
Turn the air tool upside down.
3. While pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet.
lubricated, oil will discharge through the
exhaust port during the fi rst
few seconds of operation. The
exhaust port must be directed
away from your body before
applying air pressure. Failure to follow
these instructions could result in serious
personal injury.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (Refer to replacement parts
manual for tool features). Run the
tool in reverse direction for 20 to 30
seconds. Oil will discharge from the
exhaust port when air pressure is
applied.

SPEED ADJUSTMENT

CL0060 impact will deliver a maximum of
60 ft. lb of torque in the forward direction
using 90 psig. The reduced torque in
the forward direction is only intended
to seat the fastener in preparation for
final torquing. DO NOT use this tool
for final tightening threaded fasteners.
Always manually torque the fastener
using a calibrated torque wrench to the
recommended torque after using this
tool. To remove lugs or bolts, set lever to
reverse position.
tighten the
bolts. Follow the manufacturer's
recommendations for torque. Over
tightening of the bolts may result in
minor or moderate injury.
Maintenance
Release all pressure
before attempting to
After an air tool
has been
DO NOT over
www.ch-commercial.com
install, service, relocate or perform any
maintenance on the air system. Personal
injury could occur.
IMPACT MECHANISM LUBRICATION
The impact mechanism is lubricate at
the factory and does not require further
lubrication. During tool servicing the
impact mechanism needs to be cleaned
and re-lubricated using a Hi-Temperature
Lithium wheel bearing grease.
Apply grease to the pins, hammers, anvil
and front bushing.
STORAGE
The impact wrench must be lubricated
before storing. Follow the air motor
lubrication instructions with an exception
to step 4.
DO NOT run the
impact wrench for
more than 3 seconds. Operating the unit
for longer period of time will decrease
the amount of oil remains in the unit
during storage; which could damage the
tool and void the warranty.

TECHNICAL SERVICE

For information regarding the operation
or repair of this product, please call
1-855-504-5678.
REPLACEMENT PARTS
INFORMATION
For information regarding where to order
replacement parts, call toll free 1-855-
504-5678.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
CL0060
5