Overhead Rigging - Briteq LED UV-GUN 60W Manual De Instrucciones

ENGLISH
DESCRIPTION:
1. BRACKET: with knobs on both sides to fasten the unit and a mounting hole to fix a mounting hook.
2. SAFETY EYE: used to attach a safety cable when the unit is rigged, see paragraph "overhead rigging"
3. Mains input: equipped with a 1m mains cable.
4. Fuse holder: always replace a damaged fuse with a fuse of the same type and electrical specifications!
5. DISPLAY shows the various menus and the selected functions.
6. DMX INPUT: 3pin male XLR-connector used to connect the projector with the DMX controller or with the
previous unit in the DMX chain.
7. DMX OUTPUT: 3pin female XLR-connector used to connect the projector with the next unit in the DMX
chain.
8. MODE button: used to browse the different functions in the menu
9. DOWN button: to lower the values shown on the display.
10. UP button: to increase the values shown on the display.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
BRITEQ
®
3/34
USER MANUAL
LED UV-GUN 60W