Transcend 365 miniCPAP Manual De Usuario página 15

Ocultar thumbs Ver también para 365 miniCPAP:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Transcend 365 miniCPAP Quick Guide
Heater over-temperature detected.
More details about which error disabled the heater will be displayed on the standby screen
(see LCD indicators in Standby Mode section) after therapy completes.
Standard User Modes
Normal operation consists of four modes:
Off
When the device is not connected to a power source, the device is off.
Standby
When power is applied to the device the LCD screen lights up and the
CPAP enters Standby Mode. Standby Mode is also initiated by pressing
the power button when the device is in On Mode or if the mask is
removed while in On Mode. As long as power is supplied to the device
it will remain in Standby Mode until On or Drying Mode is initiated.
On
When in On Mode, the blower is working and regulated device therapy
pressure is being generated. The LED lights remain off. On Mode is
initiated by pressing the center button when the device is in Standby
Mode and the mask is worn by the patient.
Drying Mode
This mode is accessed from Standby mode. Press and hold the Up and
Down buttons at the same time for three seconds to start Drying Mode.
This mode will last 30 minutes unless you interrupt it by pressing any
button. Drying mode flushes your CPAP device, tubing and mask of
residual moisture left from a therapy session.
Starting Therapy
Allow the Transcend 365 miniCPAP to adjust to ambient temperature after removing it
from storage. To begin therapy, plug in the power supply to your Transcend 365 miniCPAP
and press the center button to begin therapy. Press the down button to reactivate Ramp,
if desired.
NOTE:
To begin therapy from the home screen, first ensure that no icons are
highlighted, then press the center button. You may also start therapy from any
screen by holding the center power button for three seconds.
Page 15

Publicidad

Tabla de contenido
loading

Tabla de contenido