Transportingand Storage - Charmglow 810-7400-S Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

COOKING GRILLS
Clean with mild soap detergent
and water. A brass bristled brush or a nylon cleaning
pad can be used
to remove residue from the stainless steel surfaces.
Do not use steel wire bristles to clean the cooking
grills. Steel can cause the finish to chip or crack. DO NOT use a commercial
oven cleaner.
HEAT DISTRIBUTION PLATES
Periodically,
it may be necessary
to inspect and clean the heat distribution
plate to prevent excess
grease build-up.
When the grill is cold, remove the cooking grills. Inspect the heat distribution
plates
and replace if broken or damaged.
Do not allow heat distribution
plates to become damaged
to the
extent that they may fall through onto the burners.
Replace the heat distribution
plates and cooking
grills and light the burners. Operate
the grill on "HIGH" for 10 minutes to remove the excess grease.
TRANSPORTINGAND STORAGE:
Never move a grill when it is hot or when objects are on the cooking surfaces.
Make sure that cylinder valve is shut off. After moving the grill check that all gas connections
are free of leaks. Refer to instructions
for Leak Testing.
DO NOT store a spare LP gas cylinder (filled or empty) under or near the grill.
Never store flammable
liquids or spray canisters
under or near the grill.
DO NOT extinguish
grease fires using water.
If the outdoor cooking
gas appliance
is not in use, the gas must be turned off at the supply
cylinder.
Storage of an outdoor
cooking gas appliance
indoors is permissible
only if the cylinder
is
disconnected
and removed from the outdoor cooking gas appliance.
Cylinders
must be stored outdoors out of reach of children and must not be stored in a
building,
garage or any other enclosed area.
When removing
the grill from storage, spider webs or other debris may be blocking the burner.
See "Burner
Assembly/Maintenance"
under Proper Care and Maintenance.
BEFORE STORING YOUR GRILL:
Ensure that the cylinder valve is fully closed.
Clean all surfaces.
Lightly coat the burners with cooking oil to prevent excess rusting.
If storing the grill indoors, disconnect
the LP tank and leave the LP tank OUTDOORS.
Place a protective
cap cover on the LP tank and store the tank outdoors
in a well ventilated
area out
of direct sunlight.
Clean burner prior to use after storing, at the beginning
of grilling season or after a period of one
month not being used. Spiders and insects like to build nests in burner tubes (especially
during colder
months). These nests can cause fires in burner tubes or under grill.
If storing the grill outdoors,
cover the grill with a grill cover for protection
from the weather.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido