Important; Recline Adjustment - Nuna Prym Manual De Instrucciones

6 -
The completely assembled enhanced child
restraint is shown as (8).
Check to make sure the base is securely installed
by pulling on both ISOFIX connectors.
The ISOFIX connectors must be attached and
locked onto the ISOFIX anchor points. (8)-1
The load leg must be installed correctly with
green indicator. (8)-2
7 -
To remove the enhanced child restraint, press the
ISOFIX adjustment buttons (9)-1 and pull the base
away from the seat. (9)-2
8 -
Then while squeezing the ISOFIX release button
and secondary lock on the ISOFIX connectors
remove from the vehicle. (10)
9 -
Press the ISOFIX adjustment buttons to store the
ISOFIX. (11)
Use Side Impact Shield
Ensure the side impact shield is locked in the
open position for maximum side impact safety.
1 -
Side impact shields are automatically activated
when the harness buckle is moved back into
position and the harness is tightened, both sides
will be opened automatically. (12)
IMPORTANT: Please note that unfolding the side
impact protection elements do NOT mean that
the child is already restrained tight enough.
15
PRYM instructions
2 -
The side impact shield opposite the vehicle door
can be closed to allow more seating space, if
needed. The side closest to the vehicle exterior
should always be in the open position. (13)
3 -
The side impact shield can be manually opened
as shown on (14).

Recline Adjustment

Squeeze the recline adjustment button (15) to adjust
the enhanced child restraint to the proper position.
The recline angles are shown as (16).
Please recheck the load leg position after reclining.
There are 7 recline angles for baby mode and 7
positions for toddler mode.
Height Adjustment for Head Support
and Shoulder Harnesses
Check that shoulder harness straps are set at the
proper height.
Squeeze the head support adjustment lever (17)
while pulling up or down on the head support until it
snaps into one of the 8 positions. The head support
positions are shown as (18).
When used rearward facing, the shoulder harness
height must be even with or below the top of
child's shoulders. (19)(20)
When used forward facing, the shoulder harness
height must be even with the top of child's
shoulders. (21)
16
PRYM instructions