Dmx Linking - Chauvet COLORado 1 Solo Guía De Referencia Rápida

COLORado 1 Solo QRG EN
This product has an auto-ranging power supply that can work with an input voltage
AC Power
range of 100–240 VAC, 50/60 Hz.
Power Linking You can link up to 24 COLORado 1 Solo products at 120 V, 40 products at 208 V,
or 45 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
AC Plug
Connection Wire (U.S.) Wire (Europe) Screw Color
AC Live Black Brown Yellow/Brass
AC Neutral White Blue Silver
AC Ground Green/Yellow Green/Yellow Green
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
The COLORado 1 Solo will work with a DMX controller using a 5-pin DMX

DMX Linking

serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The COLORado 1 Solo uses a 3- or 5-pin DMX data connection for its DMX
DMX Connection
personalities: HSIC, SSP, TOUR, TR16, and STD.Y. See the User Manual for
information about connecting and configuring the product for DMX operation.
Note: For optimum control of the 16-bit dimming channels in the TR16 and
STD.Y personalities, be sure that both dimming curves in SETTING >
DIMMER are set to OFF.
Master/Slave The COLORado 1 Solo uses the DMX data connection for its Master/Slave mode.
See the User Manual for information about connect and configure the product for
Connection
master/slave operation.
3