Power Linking; Replacing The Fuse; Dmx Linking; Dmx Connection - Chauvet ROGUE R2 SPOT Guia De Inicio Rapido

Rogue R2X Spot QRG
AC Power

Power Linking

AC Plug

Replacing The Fuse

DMX Linking

DMX Connection

This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
You can link up to 5 Rogue R2X Spot products at 120 V, 8 products at 208 V, or 9
products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Rogue R2X Spot will work with a DMX controller using a 3- or 5-pin DMX
data connection. A DMX Primer is available from www.chauvetprofessional.com.
The Rogue R2X Spot uses a 3- or 5-pin DMX data connection for its DMX
personalities: 18CH and 21CH. See the User Manual for information about
connecting and configuring the product for DMX operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
3
Screw Color
Brown Yellow/Brass
Blue Silver
Green
EN