Operation; Checking The Battery Charge Level - Troy-Bilt TB4200 Manual Del Operador

WARNING:
Do not expose power tools to rain or wet
conditions.

CHECKING THE BATTERY CHARGE LEVEL

Press the charge meter button on the battery. The number of lights
that illuminate will indicate the current charge level of the battery
(Fig. 7). If all four lights are dark, charge the battery before any
further use.
NOTE: While in use, lithium-ion batteries provide power with
minimal power fade. When the battery is fully discharged, it will
immediately cut power to the unit and require charging.
HOLDING THE UNIT
WARNING:
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when operating this unit.
Wear a face mask or dust mask if the operation is dusty.
• Stand in the operating position (Fig. 8). Stand up straight. Do not
bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right arm
slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
USING THE BOOST BUTTON
Press the boost button to switch between MAX and ECO modes, as
needed (Fig. 9).
• MAX mode provides maximum power for tough jobs.
• ECO mode conserves energy for maximum run time. ECO mode
is appropriate for most jobs.
NOTE: The unit will reset to ECO mode a few seconds after the
motor is turned off.

OPERATION

0% - 25%
25% - 50%
11
75% - 100%
50% - 75%
Charge Meter
Button
Fig. 7
Fig. 8
Boost Button
Fig. 9