Stopping And Cleaning; Maintenance - Sagola 6110 Manual De Instrucciones Y Lista De Repuestos

1. Disconnect the pressure pot from the air
compressor.
2. Despressurise the
pressure pot by first
turning wheel (1) and
then wheel (2).
The unit must be overhauled on a periodic
basis to check the status of its components and
replace these when they are not in perfect
condition.
IN ORDER TO OBTAIN THE BEST POSSIBLE
RESULTS, ALWAYS USE ORIGINAL SAGOLA
SPARES THAT GUARANTEE TOTAL INTER -
CHANGEABILITY, SAFETY AND PERFECT
OPERATION.
In order to carry out maintenance or repairs,
first disconnect the unit from the compressed
DESCRIPTION
Lid packing
Connections
Hoses
Pressure regulators
Safety valve
Discharge valve

8. STOPPING AND CLEANING

(1)
(2)

9. MAINTENANCE

FREQUENCY
Start operation Weekly
- 18 -
3. Once the
pressure pot is
open, clean with
the appropiate
thinner.
4. Close it again and perform the start-up
rouline, re-circulating the thinner through the
hoses and guns, as many times as necessary.
air distribution network.
Do not apply excessive force or inadequate
tools for maintaining and cleaning the unit.
Some repairs must be done with special tools
on some occasions. In these cases, you must
contact the Customer Service of SAGOLA.
Any handling of this product by non-authorised
personnel would render the warranty null and
void.
OPERATION
Monthly
Check conditions
Inspection and tightening
Check conditions
Check conditions
Visual check
Visual check