SMA RoofCommKit-P2-US Instrucciones De Instalación página 14

4 Mounting
2. Remove the enclosure lid of the DC Connection Unit. Unscrew all screws with a Torx
screwdriver (TX 25) and remove the enclosure lid carefully forward.
3. Set the screws and the enclosure lid aside and store safely.
4. Plug the pin strip with the long pin side into the
socket terminal strip on the back of the module.
5. Plug the module into the module slot M2. Perform the following steps:
• Guide the three guide pins on the
communication assembly through the holes in
the module.
• Carefully push the module down on the upper
edge and on the connection sockets until it
audibly snaps into both side locking tabs of the
communication assembly. The plug on the back
of the module is automatically pushed into the
socket terminal strip of the communication
assembly.
14 RoofCommKit-P2-US-IA-xx-10
SMA Solar Technology America LLC
Installation manual
CLICK CLICK