Telstar Bio II Advance Manual Del Usuario página 62

Tabla de contenido

Publicidad

SP
d)
La cabina debe ser sellada con un protector plástico estanco antes de la fumigación para
asegurar la ausencia de fugas de formaldehído. Este protector ha sido probado mediante el
test de amoniaco, consistente en someter a una presión de 80 Pa con una atmósfera
interior de amoniaco y externamente comprobar la ausencia de fugas con un detector de
amoniaco.
Comprobar que la lámina PVC o aluminio plastificada es continua (una sola pieza
sin uniones que dificulten el sellado)
e) Poner la lámina PVC o aluminio plastificada bajo la mesa soporte de la cabina (levantando
primero un lado y luego el otro)
f)
Poner en marcha la cabina, deshabilitar la toma de los enchufes y apagar los ventiladores
g) Separar el frontal de la cabina y subir el cristal a posición máxima
h) Conectar el vaporizador con amoniaco al enchufe de la zona de trabajo manteniendo
inhabilitado mediante el control del display
i)
Cubrir totalmente la cabina mediante la bolsa de PVC hermética dejando salir de esta, por
la parte inferior, únicamente el cable que conecta la cabina a la corriente
EN
d)
The safety cabinet should be sealed before fumigation to ensure that no formaldehyde can
leak into the laboratory or the other rooms. For that, cover the safety cabinet with the
plastic cover. This plastic cover is completely airtight and has been tested against leaks
with the ammonia test. It consists of testing the plastic cover at a pressure of 80 Pa with
an ammonia atmosphere inside. Externally, an ammonia detector checks no leakage.
that the PVC sheet or PVC laminated aluminum sheet is continuous (one single piece
without any joint)
e) Place the PVC sheet or PVC laminated aluminum sheet below the table support of the
cabinet (by raising first one side and then the other side)
f)
Switch on the cabinet, disable the socket inlets and switch off the fans
g) Separate the frontal of the cabinet and raise the glass to the maximum position
h) Plug in the vaporized with ammonia into the working surface while keeping the plug
switched off by the display control
i)
Cover totally the cabinet using the hermetic PVC bag and letting go out only the cabinet
power cord by the lower part of the bag
A5.3-BIOIIADVANCE-SP-EN-1302
Check
4

Publicidad

Tabla de contenido
loading

Tabla de contenido