SUN M3 - M6
Electrode positioning
Check the electrodes and baffle are in the right positions, according to the distances shown below.
THE TIP OF THE IGNITION ELECTRODE MUST FALL WHERE THERE IS ONE OF THE PILOT
ORIFICES.
The distances should be checked after any work done on the head.
Make sure there is no electric power and the gas is shut off.
Disassembly sequence
• Turn off the gas
• Disconnect the burner electrically by removing connector "A"
• Disconnect the two electrical connections "G" from the valve
• Remove the gas valve "B"
G
G
EN
Combustion head
L
fig. 5
fig. 6
Cod. 3540G431 - 11/2007 (Rev. 00)
B
A
31