Refrigerator Location - GE Appliances TFX26ZPDAA Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (onsomo
motions)
Ifthe refiigerator
has an icemaker, it xdll have to be
connected
1o a cold
water
lille.
A water supply kit (containing copper tubing,
shutoffvalve, fittings and insu_ucfions) is available
at exua cost flom your dealer or fiom Parts and
Accessories, 800-626-2002.
Refrigerator Location
Do not install the refligera/or
where tile
temperature
will go below 60°F (16°C)
because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it
flflly h)aded.
Clearances
Allow the folh)xdng clearances for ease of
installation,
proper air cir(ulation
and
plumbing and elecui(al (onne(dons:
Sides
,)/8
(ID IIlIIl)
Top
1" (25
IllIll)
If built-in, allow 7/8" {22 ram) for hinge covers.
If the refiigerator
is against a w:tll on either side,
allow the tblh)wing door clemances:
20', 22', and 24'models
3/4" (19ram)
27' models
17Z' (38 ram)
Back 1" (25
IIllI1)
Rollers
The milers have 3 purposes:
[_] Rollers a(!just so the door ch)ses easilywhen
opened about halfivay. [Raise the fiont about
,) _ (15 ram) fiomthetloor.]
To assure that tile doors will close m_tomatically
tiom a halt_xW open position, there is a buih-in tilt
fiom the flont to the back of the cabinet. Side-b)=
side retiigerators
also have spedally designed door
hinges that lift both doors slightly when opened,
allowing the torce of gravity to help close them
se(urely.
[_ Rollers adjust so tile refiigerator
is firmly
positione(i on tile floor and does not wo])ble.
_] Rollers allow you
to move
tile refiigerator
away
Y
fi'oln the wall}br (leaning.
Toadjustthemilers,remove tile base grille by pulling
it out at tile bottom.
Turn the roller ac!iusting screws clockwiseto raise
tile refiigerator, counterclockwise to Iowerit. Use an
ac!iustable x_Tench (3/8" hex head 1)oh) or pliers.
7"0 r eplace base grille, align prongs on back of grille
wifll (lamps in (abinet and push forward until grille
snaps into pla(e.
/4

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido