Service And Repairs - Porter Cable PC60TPAG Manual De Instrucciones

uSING cuttING WheelS
WARNING
: Do not use edge grinding/cutting wheels for surface grinding
applications because these wheels are not designed for side pressures encountered with
surface grinding. Wheel breakage and injury may result.
1. Allow tool to reach full speed before touching tool to work surface.
2. Apply minimum pressure to work surface, allowing tool to operate at high speed.
Cutting rate is greatest when the tool operates at high speed.
3. Once a cut is begun and a notch is established in the workpiece, do not change the
angle of the cut. Changing the angle will cause the wheel to bend and may cause
wheel breakage.
4. Remove the tool from work surface before turning tool off. Allow the tool to stop
rotating before setting it down.
MAINteNANce
cleANING
WARNING
: Blowing dust and grit out of the motor housing using compressed air
is a necessary maintenance procedure. Dust and grit from metal grinding often
accumulate on interior surfaces and could create an electrical shock hazard if not
cleaned out.
WARNING
: AlWAyS use safety glasses. Everyday eyeglasses are Not safety
glasses. Also use face or dust mask if operation is dusty. AlWAyS WeAR ceRtIfIed
SAfety eQuIPMeNt:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
Use only mild soap and a damp cloth to clean the tool. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
IMPoRtANt: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized
service centers or other qualified service personnel, always using identical replacement parts.
luBRIcAtIoN
Porter-Cable tools are properly lubricated at the factory and are ready for use. Tools
should be lubricated regularly every year depending on usage. (Tools used on heavy
duty jobs and tools exposed to heat may require more frequent lubrication.) This
lubrication should be attempted only by trained power tool repair person such as those
at Porter-Cable service centers or in other qualified service personnel.

SeRvIce ANd RePAIRS

All quality tools will eventually require servicing and/or replacement of parts. For information about
Porter-Cable, its factory service centers or authorized warranty service centers, visit our website
at www.portercable.com or call our Customer Care Center at (888) 848-5175. All repairs made by
our service centers are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North, Jackson,
Tennessee 38305 - Attention: Product Service. Be sure to include all of the information shown on
the nameplate of your tool (model number, type, serial number, etc.).
AcceSSoRIeS
WARNING
: Since accessories, other than those offered by Porter-Cable, have
not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only Porter-Cable recommended accessories
should be used with this product.
A complete line of accessories is available from your Porter-Cable Factory Service
Center or a Porter-Cable Authorized Warranty Service Center. Please visit our Web
Site www.portercable.com for a catalog or for the name of your nearest supplier.
15 15