ATON DH44 Manual Del Usario página 17

DH44 4 Source, 4 Zone Digital Audio Router
Digital Coaxial (DIG COAX)
Use a Digital Coaxial cable to connect an audio source with a Digital Coaxial output to the
DH44's Source Input as shown in Figure 3-2. Digital Connections provide the best audio qual-
ity and should be used if available. If both a Digital Coaxial connection and a Digital Optical
connection are present on the audio source, use only one. DO NOT connect both Coaxial and
Optical outputs to the DH44.
Set the Coaxial/Optical
Selection Switch
to the COAX position.
NOTE: Multi-channel digital audio formats (5.1, 7.1 etc.) are not supported by the DHSIP and DH44. However, many audio/video
sources allow you to change the digital output to PCM Stereo. In most cases this will allow multi-channel audio sources to output
a "summed" stereo signal through the digital output. Consult the audio/video source manual for details.
NOTE: Some audio sources which utilize a digital output require that you enable the digital output before it will function. If there
is no audio present, check the setup menu of the audiosource to confirm that the digital output is enabled.
Figure 3-2: Source Input - Digital Coaxial
Digital Optical (OPTICAL)
Use a Digital Optical (TOSLINK) cable to connect an audio source with a Digital Optical output
to the DH44's Source Input as shown in Figure 3-3. Digital Connections provide the best audio
quality and should be used if available. If both a Digital Coaxial connection and a Digital Optical
connection are present on the audio source, use only one. DO NOT connect both coaxial and
optical outputs to the DH44.
Set the Coaxial/Optical
Selection Switch
to the OPT position.
NOTE: Multi-channel digital audio formats (5.1, 7.1 etc.) are not supported by the DHSIP and DH44. However, many audio/video
sources allow you to change the digital output to PCM Stereo. In most cases this will allow multi-channel audio sources to output
a "summed" stereo signal through the digital output. Consult the audio/video source manual for details.
NOTE: Some audio sources which utilize a digital output require that you enable the digital output before it will function. If there
is no audio present, check the setup menu of the audiosource to confirm that the digital output is enabled.
Figure 3-3: Source Input - Digital Optical
© 2008 • All rights reserved.
DH44
Digital
Coax
Cable
Digital Source
Digital Output
SPDIF
DH44
Digital
Optical
Cable
Audio Source
Digital Optical
Output
DIGITAL
OPTICAL
15