Zone Out - ATON DH44 Manual Del Usario

ZONE OUT

The ZONE OUT RJ-45 connectors interface with DHTP1 Amplifi ed Touch Pad Controllers
through Cat-5 cables wired to the T-568A Standard. These connectors carry IR information
from the Touch Pads as well as audio information to the Touch Pads. Status information is also
carried between the DH44 chasssis and the Touch Pads. While a great deal of information is
handled by the ZONE OUT connections, the connections are straightforward. Simply connect
Cat-5 cables terminated to the T-568A confi guration (Figure 3-8) from each Touch Pad to the
corresponding ZONE OUT connector as shown in Figure 3-9.
Note: For wire runs up to 150', the Cat-5 connections are all that is necessary. For wire
runs over 150', use the AUX POWER OUT connectors as described in the section entitled
Auxiliary Power Connector (AUX POWER OUT).
1 2 3 4 5 6 7 8
Shown tab
down
Figure 3-8: T-568A Wiring Standard
DHTP1 Rear
- +
L+ L- R+ R-
SPEAKERS PWR IN
- +
L+ L- R+ R-
SPEAKERS PWR IN
DHTP1 Rear
Figure 3-9: ZONE OUT Connections
18
DH44 4 Source, 4 Zone Digital Audio Router
1 2 3 4 5 6 7 8
DH44
Cat-5
Cat-5
Cat-5
Cat-5
©2008 • All rights reserved.
DHTP1 Rear
- +
L+ L- R+ R-
SPEAKERS PWR IN
-
+
L+ L- R+ R-
SPEAKERS PWR IN
DHTP1 Rear