Remaining Risk Factors; Operation Instructions - Zipper Maschinen ZI-ABH1500D Instrucciones De Servicio







11.2 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is required.
A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors totally. The
following hazards may arise in connection with the machine´s construction and design:
 Risk of injury to the hands / fingers by the tool and tool mount during operation.
 Risk of injury due to sharp edges of the workpiece, especially in non-fixed with a suitable tool / device
workpiece.
 Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety regulations must be
observed with regard to clothing.
 Risk of injury due to contacting with live electrical components.
 Risk of injury due to dust emissions, treated with harmful agents workpieces
 Risk of injury to the hearing by prolonged labor without hearing protection
 Risk of injury to the eye by flying debris, even with safety goggles.
 Health damage caused by hand-arm vibrations if the equipment is used over a prolonged period or is not
properly guided and maintained.
These risk factors can be minimized through obeying all security and operation instructions, proper machine
maintenance, proficient and appropriate operation by persons with technical knowledge and experience.
12 OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be used. Check in
particular the safety equipment, electrical controls, electric cables and screwed connection for damage and if
tightened properly. Replace any damaged parts before operating the device.

12.1 Operation instructions

Perform all machine settings with the machine being disconnected from the
power supply!
Excessive pressure may cause material damage!
 When chiselling only slight pressure is required

Too much pressure unnecessarily overload the motor and cause damage!
 Use auxiliary handles supplied with the tool
Loss of control can cause personal injury
 Hold the machine by insulated gripping surface
The contact with a live wire can cause electric shock
 Prior to chiselling into walls, ceilings or floors, ensure there are no electric cables or
conduits inside.
 Checking the mains, whether they comply with the relevant national standards and
guidelines (especially Assemblies for Construction Sites)

Use only clean working tool. Lightly lubricate the chisel shank before use with a grease.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ABH1500D / ZI-ABH1700D
Avoid body contact with earthed
Before starting the machine remove any adjusting wrenches and screwdrivers
Parts can cause severe cut injuries
Keep the chisels sharp and clean, so they get stuck less often and are easier to
guide
Keep any machine that is not being used out of reach of children
WARNING
WARNING
ATTENTION
NOTICE
OPERATION
22