Cleaning; Disposal; Trouble Shooting - Zipper Maschinen ZI-ABH1500D Instrucciones De Servicio

13.3 Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do not
remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces as well
as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution

13.4 Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local dealer
for a replacement unit, the latter is obliged to exchange your old.
14

TROUBLE SHOOTING

Disconnect the machine from the power supply prior to any checks performed at the ma-
chine itself!
Trouble
Machine stops or will not start
Impact system blocks
Drill stucks
MANY MALFUNCTIONS AND DEFECTS CAN BE AVOIDED BY LETTING THE MACHINE BE
CONNECTED TO YOUR POWER SUPPLY BY A CERTIFIED ELECTRICIAN
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-ABH1500D / ZI-ABH1700D
NOTICE
Possible cause
 Machine unplugged
 Cord damaged
 Overload tripped
High fat friction due to low

temperatures
 Moving parts are blocked
 Disruptive reinforced steel
NOTICE
TROUBLE SHOOTING
Solution
 Check all power connections
 Change cable
Allow motor to cool and reset

by pushing off switch
Warm up the machine in a

warm environment
 Change damaged parts
 Fix new hole
26