Beko WTE 6501 B0 Manual Del Usuario página 24

7 Troubleshooting
Program does not start after closing the door.
•Start / Pause / Cancel button was not pressed. >>>
Programme cannot be started or selected.
• Washing machine has switched to self protection mode due to a supply problem (line voltage, water pressure, etc.). >>>
To cancel the programme, turn the Programme Selection knob to select another programme. Previous programme will be
cancelled. (See "Canceling the programme")
Water in the machine.
• Some water might have remained in the product due to the quality control processes in the production. >>>
failure; water is not harmful to the machine.
Machine vibrates or makes noise.
• Machine might be standing unbalanced. >>>
• A hard substance might have entered into the pump filter. >>>
• Transportation safety bolts are not removed. >>>
• Laundry quantity in the machine might be too little. >>>
• Machine might be overloaded with laundry. >>>
hand to balance it homogenously in the machine.
• Machine might be leaning on a rigid item. >>>
Machine stopped shortly after the programme started.
• Machine might have stopped temporarily due to low voltage. >>>
normal level.
Programme time does not countdown. (On models with display)
• Timer may stop during water intake. >>>
water. The machine will wait until there is sufficient amount of water to avoid poor washing results due to lack of water. Timer
indicator will resume countdown after this.
• Timer may stop during heating step. >>>
temperature.
• Timer may stop during spinning step. >>>
unbalanced distribution of the laundry in the drum.
• Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to
the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
Foam is overflowing from the detergent drawer.
• Too much detergent is used. >>>
the detergent drawer.
• Put detergent into the machine suitable for the programmes and maximum loads indicated in the "Programme and
consumption table". When you use additional chemicals (stain removers, bleachs and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme
• Excessive foam might have occurred and automatic foam absorption system might have been activated due to too much
Use recommended amount of detergent.
detergent usage. >>>
• Machine does not switch to spinning step when the laundry is not evenly distributed in the drum to prevent any damage to
the machine and to its surrounding environment. Laundry should be rearranged and re-spun.
A
:
If you cannot eliminate the problem although you follow the instructions in this section, consult your
warning
dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
24 / EN
*Press the Start / Pause / Cancel button.
Adjust the feet to level the machine.
Remove the transportation safety bolts.
Add more laundry to the machine.
Take out some of the laundry from the machine or distribute the load by
Make sure that the machine is not leaning on anything.
Timer indicator will not countdown until the machine takes in adequate amount of
Timer indicator will not countdown until the machine reaches the selected
Automatic unbalanced load detection system might be activated due to the
Mix 1 tablespoonful softener and ½ l water and pour into the main wash compartment of
Clean the pump filter.
It will resume running when the voltage restores to the
Washing Machine / User's Manual
This is not a