Appropriate Installation Location - Beko WTE 6501 B0 Manual Del Usuario

2 Installation
Refer to the nearest Authorised Service Agent for
installation of the product. To make the product
ready for use, review the information in the user
manual and make sure that the electricity, tap water
supply and water drainage systems are appropriate
before calling the Authorized Service Agent. If they
are not, call a qualified technician and plumber to
have any necessary arrangements carried out.
C
NOTE :
Preparation of the location and
electrical, tap water and waste water
installations at the place of installation is under
customer' s responsibility.
NOTE :
Make sure that the water inlet and
discharge hoses as well as the power cable are
not folded, pinched or crushed while pushing
the product into its place after installation or
cleaning procedures.
B
DANGER:
Installation and electrical
connections of the product must be carried out
by the Authorized Service Agent. Manufacturer
shall not be held liable for damages that
may arise from procedures carried out by
unauthorized persons.
A
CAUTION:
Prior to installation, visually check
if the product has any defects on it. If so, do not
have it installed. Damaged products cause risks
for your safety.

2.1 Appropriate installation location

• Place the machine on a rigid floor. Do not place it
on a long pile rug or similar surfaces.
• Total weight of the washing machine and the
dryer -with full load- when they are placed on top
of each other reaches to approx. 180 kilograms.
Place the product on a solid and flat floor that has
sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product at places where
temperature may fall below 0ºC.
• Place the product at least 1 cm away from the
edges of other furniture.
6 / EN
2.2 Removing packaging reinforcement
Tilt the machine backwards to remove the packaging
reinforcement. Remove the packaging reinforcement
by pulling the ribbon.
2.3 Removing the transportation locks
A
WARNING:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
WARNING:
Remove the transportation safety
bolts before operating the washing machine!
Otherwise, the product will be damaged.
1. Loosen all the bolts with a suitable spanner until
they rotate freely (C).
2. Remove transportation safety bolts by turning
them gently.
Washing Machine / User's Manual