Remote Control Battery Installation And Replacement - Hitachi P42H401 Manual Del Usuario

Ocultar thumbs Ver también para P42H401:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

test-bleed
3/3/06
10:18 AM
Accessories
Check to make sure you have the following accessories before disposing of the packing material.
³
Remote Control
³ Remote Control Unit CLU-4371UG2
· Two "AA" size, 1.5V batteries (P# FQ00021).
» Table Top Stand (UX27661 42" model)
¿ Power Cord (P# EV01841).

REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT

1.
2.
3.
4.
5.
4
Page 4
·
Two "AA" size,
1.5V batteries
»
Table Top Stand
(50" included)
For U.S. models:
For optional accessories, please access our web site at:
www.hitachi.us/tv
CAUTION:
1. Ceiling mounting is not recommended. Mounting the panel on the ceiling does not
provide adequate ventilation for the electronics or proper support for the front glass
panel. This plasma television product is designed for a maximum tilting angle of 45
degrees from vertical.
2. This stand for use only with Hitachi P42H401 and P50H401. Use with other
apparatus is capable of resulting in instability causing possible injury.
3. The wall mount unit for the 50" and 42" models is WM07S and for the
55" models is WM07L. Please see page 7 for important information related
to the wall mount. Wall Mout unit is an optional accessory (Not Included).
(Part No. HL02075).
(UX27281 50" models).
Open the battery cover of the remote control by pushing down and sliding the back cover off.
Insert two new "AA" size batteries for the remote control. When replacing old batteries, push them towards the
springs and lift them out.
Match the batteries to the (+) and (-) marks in the battery
compartment.
Insert the bottom of the battery, the (-) side, into the battery
compartment first, push towards the springs and insert the
top of the battery, the (+) side, into place. Do not force the
battery into the battery compartment.
Replace the cover.
CAUTION: Do not insert batteries with '+' and '-' polarities reversed as this may cause the batteries
to swell or rupture resulting in leakage.
¿
Power Cord
»
Table Top Stand
(42" included)
Note: Please visit our
website for optional
accessories.
Bottom View (Remote Control)
Lift up on tab to remove back cover.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

P50h401P55h401

Tabla de contenido