VONROC ET502AC Traducción Del Manual Original página 8

EN
Stapling
• Press the switch (3).
The tool will cause a re bound because of
the impact it operates with. Keep this in
mind. For long nails and staples this can
cause wrong stapling or nailing. When
backpressure is applied wrong stapling or
nailing can be avoided.
4. MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
This machine has been designed to operate over a
long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper machine care and regular cleaning.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
In case a staple or nail is jammed in the tool, follow
the procedure below:
• Place the machine in lock position (4)
• Disconnect the tool
• Open the cartridge shaft (2) by pulling the reload
lever (1) and let the jammed nails/staples fall out.
• Reload the machine, see chapter " Loading the
nails or staples" for instructions.
• Test the machine on a piece of scrap.
Cleaning
Regularly clean the device's casing with a soft
cloth, preferably after each use. Keep the fan slits
free of dust and dirt. Remove tough dirt using a
soft cloth, dampened with soapy water. Do not use
solvents such as benzene, alcohol, ammonia, etc.,
which might damage the plastic parts.
8
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/
EC for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the
implied warranties of merchantability and fitness
for a particular purpose. In no event shall VONROC
be liable for any incidental or consequential dama-
ges. The dealers remedies shall be limited to
repair or replacement of nonconforming units or
parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM