3
Set-Up
Finish securing
chute control assembly
to chute support
bracket with wing nut and hex screw removed
earlier.
See Fig. 3-4.
Figure 3-4
4.
Check that all cables are properly
routed through
the cable
guide on top of the engine.
See Fig. 3-5.
Figure 3-5
ShearPins
A pair of replacement
auger shear pins and bow tie cotter
pins
are included
with your snow thrower.
Store them
in your snow
thrower's
dash panel until needed. See Fig. 3-6.
f
Figure 3-6
Chute Clean-0ut Tool
The chute clean-out
tool is fastened
to the top of the auger
housing
with a mounting
clip and a cable tie at the factory.
Cut
the cable tie before operating
the snow thrower.
See Fig. 3-7.
f
Chute Clean=out Tool
Figure 3-7
J
8
I
SECTION3--
ASSEMBLY &
SET-UP