Correct Operation Test - DELTA DORE TYDOM 2.0 Manual De Instalación

10. Correct operation test

Create a detection event to check that the installation is operational.
Switch on the system, and trigger an intrusion. Allow
the call cycle to run without touching the OFF button of
a control device.
Check that TYDOM 2.0 calls the programmed numbers
(6 at most) one after the other until a contact picks up:
- It reads the voice message and specifies the type of defect,
- It asks if you want to listen to what is happening, speak
to a person close to TYDOM 2.0, stop the call cycle and
obtain the details of the defects if an alarm control unit is
associated.
From TYDOM 2.0:
You can also trigger a test call
cycle by pressing the TYDOM 2.0's
button for 30 seconds.
You are
connected with
a telephone
transmitter
Intruder alarm
25 June 2015
>30s
To view the defect details,
type 1
1 2 3
4 5 6
7 8 9
0
Garage door
intruder alarm,
on 25 June 2015
To disable the product,
press 1
1 2 3
4 5 6
7 8 9
0
59
1 7
n°1 n°1
2 8
n°2 n°2
3 9
n°3 n°3
4 10
n°4 n°4
5 11
n°5 n°5
6 12
n°6 n°6
Example of a full cycle
with 6 programmed numbers
To stop the call cycle,
press
1 2
4 5
7 8
0
*
- the system is off - to
listen, press 2
- to listen whilst talking,
press 3
- to disconnect the call,
press twice
EN
13
n°1
14
n°2
15
n°3
16
n°4
3
6
9
#