Troubleshooting Tips; Hints On Disposal; Declaration Of Conformity - Klarstein 10030521 Manual Del Usario

Problem
Ingredients stuck in the pump.
Failing to reach 100°C.
Temperature correction.
E1 shown on display.
E2 shown on display.
According to the European waste regulation 2012/19/EU this symbol on the product
or on its packaging indicates that this product may not be treated as household waste.
Instead it should be taken to the appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. For more de-
tailled information about recycling of this product, please contact your local council or your
household waste disposial service.
Producer: Chal-Tec GmbH, Wallstraße 16, 10179 Berlin, Germany.
This product is conform to the following European Directives:
2014/30/EU (EMC)
2014/35/EU (LVD)
2011/65/EU (RoHS)
11

Troubleshooting Tips

Hints on Disposal

Declaration of Conformity

Possible cause and Solution
Flush the pump by connecting a hose to the curve
pipe.
Dismantle the pump to remove the ingredients.
Put cover on for 1 to 2 mins.
Do temperature correction. Press „-" and „+" at the
same time enter into C1 temperature correction
setting. Setting range is from -10°C to +10°C.
Sensor is open circuit, please open the underneath
and check if sensor is too tight, then pull in out and
re-connect it.
Sensor is short circuit, please open the underneath
and check if sensor is too loosen, then pull in out and
re-connect it.